How to use Tanrevel®

Exfoliate

Start by gently exfoliating your skin 24 hours before application to remove dead skin cells. This helps Tanrevel® adhere better and ensures the result lasts longer.

Charge your device

Before use, make sure your Tanrevel® Pro is charged. The device will light up red if it needs charging. Use the USB-C charger and charge the device until it lights up green.

Fill with formula

Fill your Tanrevel Pro® device with formula by removing the device's lid and opening the container. Use the pipette to fill with formula. Start with a small amount to see how far the formula goes for your use, and then refill as needed.

Apply Tanrevel® on dry and cleansed skin. Avoid using an oil-based cleanser before or after applying Tanrevel®, as it can prevent the formula from adhering properly.

Hold the device 30-40 cm away from your face and body. Use slow movements to spray over the skin for 15-30 seconds to create an even layer.

You can adjust the intensity by applying additional layers. Start with one layer, wait a short while, and increase up to three layers with Tanrevel® Pro for a deeper result.

The effect is immediate but continues to develop over 6 hours. Wait at least 2 hours before applying makeup or skincare products, and avoid showering for 6 hours after application.

Clean after each use

Make sure to use up the formula in your container.

• Remove the container from the device by twisting it counterclockwise.

• Lift the container off the device.

• Fill the container with warm tap water.

• Wipe the container and reattach it to the device.

• Spray out the water. Your Tanrevel® Pro is now cleaned.

The active ingredient in self-tanner is DHA, which is what gives you a tan. DHA is a natural sugar molecule that can cause the formula to stick and clog the device's nozzle. Avoid a patchy result and extend the lifespan of your device by cleaning it after each use.

Storage - Clean your device after each use and store it upright without formula.